GE UPVH890 Before you call for service…, Safety Instructions Operating Instructions, Problem

Safety Instructions

Operating Instructions

Troubleshooting Tips

Consumer Support

Before you call for service…

Troubleshooting Tips

Save time and money! Review the charts on the following pages, or visit GEAppliances.com. You may not need to call for service.

PROBLEM	Possible Causes	What To Do
Dryer shakes or	Some shaking/noise is normal.	• Move dryer to an even floor space, or adjust leveling legs
makes noise	Dryer may be sitting unevenly	as necessary until even.
Clothes take too long	Improper or obstructed ducting	• Check the Installation Instructions to make sure the
to dry		dryer venting is correct.
		• Make sure ducting is clean, free of kinks and
		unobstructed.
		• Check to see if outside wall damper operates easily.
	Improper sorting	• Separate heavy items from lightweight items (generally,
		a well-sorted washer load is a well-sorted dryer load).
	Large loads of heavy fabrics	• Large, heavy fabrics contain more moisture and take
	(like beach towels)	longer to dry. Separate large, heavy fabrics into smaller
		loads to speed drying time.
	Controls improperly set	• Match control settings to the load you are drying.
	Lint filter is full	• Clean lint filter before every load.
	Blown fuses or tripped circuit	• Replace fuses or reset circuit breakers. Since most
	breaker	dryers use 2 fuses/breakers, make sure both are
		operating.
	Overloading/combining loads	• Do not put more than one washer load in the dryer at
		a time.
	Underloading	• If you are drying only one or two items, add a few items
		to ensure proper tumbling.
The DRY dryness level	Load consists of a mixture	• When combining heavy and light fabrics in a load,
was chosen but load is	of heavy and light fabrics	choose MORE DRY.
still damp
	Exhaust system is blocked	• Inspect and clean exhaust system.
Control pads not	Controls accidentally put in	• Press START/PAUSE.
responding	service mode
	Controls accidentally put in	• Hold the LOCK button for 3 seconds to unlock the dryer.
	lock mode
	Controls performed an	• Reset the in-house breaker.
	incorrect operation
Dryer doesn’t start	Control panel is “asleep”	• This is normal. Press POWER to activate the control panel.
	Dryer is unplugged	• Make sure the dryer plug is pushed completely into
		the outlet.
	Fuse is blown/circuit breaker	• Check the building’s fuse/circuit breaker box and
	is tripped	replace fuse or reset breaker. NOTE: Electric dryers
		use two fuses or breakers.
	Dryer was accidentally paused	• If the light on the START/PAUSE button is flashing,
	when starting Delay Start	the dryer is paused. Press START/PAUSE to restart
		the countdown.
No numbers displayed	Dryer is continuously	• This is normal. When the dryer senses a low level of
during cycle, only lights	monitoring the amount of	moisture in the load, the dryer will display the dry time
44	moisture in the clothes	remaining.