Henny Penny OEA/OGA-342, OFE/OFG-342 Complete Control, Panel Replacement, Power Switch, Figure

		Model OFE/OFG/OEA/OGA-341, 342
2-4. COMPLETE CONTROL	Should the control board become inoperative, follow these
PANEL REPLACEMENT	instructions for replacing the board.
	1.	Remove electrical power supplied to the unit.
		To avoid electrical shock or property damage, move the
		power switch to OFF and disconnect main circuit
		breaker, or unplug cord at wall receptacle.
Figure 2-9	2.	Remove the two screws securing the control panel and lift out.
		Figure 2-9.
	3.	Unplug the wire connectors going to the control panel.
		Figure 2-10.
	4.	Remove transformer(s) from control panel. They must be
		installed on the replacement panels.
	5.	Install new control panel in reverse order.
		When plugging connectors onto new control panel, be sure the
		connectors are inserted onto all of the pins, and that the
Figure 2-10		connectors are not forced onto the pins backwards. If not
		connected properly, damage to the board could result.
2-5. POWER SWITCH	1.	Remove electrical power supplied to fryer.
		To avoid electrical shock or property damage, move the
		power switch to OFF and disconnect main circuit
		breaker, or unplug cord at wall receptacle.
	2.	Remove control panel.
Figure 2-11	3.	Label and remove wires from the switch. With test instrument
		check across the terminals of the switch with switch in the on
		position, and the circuit should be closed. In the off position,
		the circuit should be open. If the switch checks defective,
		replace by continuing with this procedure. Figure 2-11.
2-4		504