Safety, Hazardous Situation WHICH, if not | Henny Penny OFG-390

	Model OFG- 390
1-4. SAFETY	Henny Penny open fryer has may safety features incorporated.
	However, the only way to ensure a safe operation is to fully under
	stand the proper installation, operation, andmaintenance proce
	dures. The instructions in this manual have been prepared to aid you
	in learning the proper procedures. Where information is of particu
	lar importance or safety related, the words DANGER, WARNING,
	CAUTION, and NOTICE are used. Their usage is described
	below.
	SAFETYALERT SYMBOL is used with DANGER,
	WARNING, or CAUTION which indicates a personal injury
	type hazard.
	NOTICE is used to highlight especially important information.
	CAUTION used without the safety alert symbol indicates
	a potentially hazardous situation which, if not avoided,
	may result in property damage.
	CAUTION used with the safety alert symbol indicates a
	potentially hazardous situation which, if not avoided,
	may result in minor or moderate injury.
	WARNING indicates a potentially hazardous situation
	which, if not avoided, could result in death or serious
	injury.
	DANGER INDICATES AN IMMINENTLY
	HAZARDOUS SITUATION WHICH, IF NOT
	AVOIDED, WILL RESULT IN DEATH OR SERIOUS
	INJURY.

306

1-2

Image 9

Henny Penny OFG-390 manual Safety, Hazardous Situation WHICH, if not, AVOIDED, will Result in Death or Serious, Injury

Contents

OPERATOR’S Manual Page Limited Warranty for Henny Penny Equipment Keep appliance area free and clear from combustibles Datos Tecnicos Para Products CE Henny Penny Head GAS Open Fryer Specifications Table of Contents Introduction Proper CareAssistance Hazardous Situation WHICH, if not SafetyAVOIDED, will Result in Death or Serious InjuryPage Unpacking Instructions Installation Unpacking Remove the counterweights from the pallet, which areInstructions Strapped to the pallet, under the fryer Optional Ramp Unloading Model OFG 908 Selecting Position and install fryer to prevent tipping or moveLocation Ment. Restraining ties may be used for stabilization GAS Supply Ventilation of Fryer Fryer must be isolated from the gas supply piping During any pressure testing of the gas supply pipingSystem by closing its individual manual shutoff valve System at test pressures equal to or less than 1/2 Model OFG 303 Regulator Setting GAS Leak TestGAS Pressure Requirements Electrical Model OFG Page Operation Operating Components High Limit Airflow SwitchIgnition Modules Spark Ignitors Indicators SwitchesLID Operation Melt Cycle Although the Displaywillread Cool Switches IndicatorsDuring the Standby MODE, the Shorten ING is HOT and will Cause Burns SMS Controls Filling or Adding Shortening Basic Operation Cool Which could Result in Serious Burns Care ShorteningPersonal INJURY, FIRE, AND/OR Property With Prolonged USE, the Flashpoint Filtering of Shortening Turn COOK/PUMP switch to OFF position SHORTENING, IT’S Possible That the Filter Cloth or Glove When TighteningConnection AT the Union on the Filter Tube is not Tightened PROPERLY. if SO Lightingand Shutdown of the Burners Cleaning the Frypot Regular Maintenance ResetFilter Pump Motor PROTECTOR-MANUAL Preventive Maintenance Cleaning the Nylatrons MonthlyLubricating Lid Rollers -Annually Maintenanc Preventive Code Programming After the proportional control, press and release Reset Usage Special Program ModeProgramming Review Usage Speaker Frequency, Codes, Initialize System Factory Presets F/C, Gas/Electric, Speaker Volume Appliance Test Tech I/O Mode Special Program Heat ControlMode Problem Cause Correction Troubleshooting Trouble Shooting Guide Display Cause Panel Board Correction Error Codes 303 O S S a R Y Model OFG Shortening level also referred to as fill lines Gas fryers only See ignition modules Henny Penny Corp., Eaton, Ohio 45320, Revised