Henny Penny OFG-390 manual alarm sounds

		Model OFG- 390
3-15. PROGRAMMING	8.	After the proportional control, press and release the
(Continued)		FUNCTION button. “ALM 1” and “TIME” flashes in the left
		side of the display, and the first alarm time shows on the right
		side of the display. To change the time the alarm sounds,
		press the appropriate product buttons to set the time. Ex:
		Press 1,0,0,0. 10:00 flashes on the right side of the display,
		which means when the timer counts down to 10 minutes, an
		alarm sounds.
	9.	After alarm is set, press and release the FUNCTION button.
		“ALM 1”, “SELF-’’, and “CANCEL” flashes in the left side
		of the display and “YES” or “NO” shows on the right side of
		the display. The yes and no can be toggled by pressing any of
		the product buttons, (l -0). “YES” means the alarm tone
		automatically stops after several beeps. “NO” means some
		one must manually press the appropriate product button to
		stop the alarm tone.
	10.	Repeat steps 9 and 10 for alarms 2 and 3.
	11.	After alarm 3 is set, press and release the FUNCTION
		button. “FILTER” and “CYCLES” show on the left side of
		the display and the Filter Cycle value is on the right side of the
		display. The value is the number of Cook Cycles that must
		completed before the control signals the operator that the
		shortening needs filtered.
	12.	After the filter value is set, press and release the SELECT
		FUNCTION button. “EOC” and “EXIT” flashes on the left
		side of the display and “COOL” shows on the right side of
		the display. The end-of-cycle, (EOC), exit point can be set
		to COOL, SETP, or FITR, by pressing any of the product
		buttons (EOC). At the end of a Cook Cycle the controls can
		be set to return to Cool Mode, the setpoint temperature, or to
		signal the operator to filter the shortening.
	13.	After the end-of-cycle point is set, press and release the
		FUNCTION button. “HEAD” flashes on the left side of the
		display and a number shows on the right side of the display.
		The number on the right, is the number of head of chicken to
		be cooked at one time, when that product button is pressed.
		The number can be changed by pressing the appropriate
		product button. The control can then accumulate the head
		count (usage) of that product,based on counting the number
		of Cook Cycles.
703		3-17