Henny Penny OFG-390 manual Tech I/O Mode, Appliance Test

Model OFG- 390

3-16. SPECIAL PROGRAM MODE
(Continued)	Tech I/O Mode
	1. Press and hold the FUNCTION button for two seconds until
	“REG PROGRAM” shows in the display. As soon as
	“REG PROGRAM” shows in the display, press and release
	the FUNCTION button 4 times until “TECH I-O” shows in
	the display.
	2. When “CODE” shows in the display, press 2-4-6 (1-7-7-6
	for CE units). “HEAT’, and “PUMP” shows alternately in the
	display. Also, the LEDs over 1 and 3 flashes alternately.
	3. To test the heat circuit, press and hold the 1 button.
	4. To test the pump system, press and hold the 3 button.
	To test the heat output on CE units, the blower and modules
	must first be turned on .
	Appliance Test
	Press and hold the FUNCTION button for two seconds until
	“REG PROGRAM” shows in the display. As soon as
	“REG PROGRAM” shows in the display, press and release
	the FUNCTION button 5 times until “APPL TEST” shows
	in the display.
	With the power switch on, the display will show “CURR=”,
	along with the time it took the unit to heat from 250º to
	300º F (121ºto 149º C) . This is normally recorded from the
	initial heat up in the morning.

3-20 504