Henny Penny OFG-390 manual Special Program, Heat Control, MODE Continued

		Model OFG- 390
3-16. SPECIAL PROGRAM		Heat Control
MODE (Continued)	1.	Press and hold the FUNCTION button for two seconds until
		“REG PROGRAM” shows in the display. As soon as
		“REG PROGRAM” shows in the display, press and release
		the FUNCTION button 6 times until “HEAT CNTRL” shows
		in the display.
	2. When “CODE” shows in the display, press 1-2-3-4.
		“MELT”, “EXIT”, and “TEMP” flashes in the display, along
		with the shortening temperature at which the unit will exit the
		melt cycle. This should be set at 180º F (82º C), and should
		not be changed until the factory is consulted.
	3. Press and release the FUNCTION button and ”MELT”,
		“CYCLE”, and “100s” shows alternately in the display, along
		with the period (pulse) length of 4000. This should not be
		changed until the factory is consulted.
	4.	Press and release the FUNCTION button twice and
		“MELT”, “ON-”, “TIME”, and “100s”, shows alternately in
		the display, along with the length of time the heat is on. This
		should be set at 1700, and should not be changed until the
		factory is consulted.

5. Press and release the FUNCTION button three times and “COOL”, “SET-”, and “POINT” shows alternately in the display, along with the temperature at which the control exits the melt cycle. This is set at 250º F (121º C), and should not be changed until the factory is consulted.

6. Press and release the FUNCTION button four times and “AUTO”, and “IDLE” shows alternately in the display, along with “OFF”. This should not be changed until the factory is consulted.

7. Press and release the FUNCITON button five times and “AUTO”, “IDLE”, and “MMSS” shows alternately in the display, along with “0:00”. This should not be changed until the factory is consulted.

8. The last 3 functions in the Heat Control Mode are used by the factory only, and should not be changed.

703 3-21