Even

if the DVD video

The

DVD

video camera/recorder

will

automatically

turn on

to

camera/recorder

is off,

recognize

a disc: Closing

the

cover

witl automatically

turn

the

opening

the cover

will

DVD

video

camera/recorder

off.

 

 

 

cause

the ACCESS

 

 

 

 

 

 

 

 

indicator

to blink.

 

 

 

 

 

 

 

 

 

During

 

recording

 

 

 

 

 

 

 

 

 

46

Pressing the REC or PHOTO button wil! not

start recording.

Recording starts but stops immediately.

LCD screen is hard to see.

Focus is not correct.

An error message for repair appears,

Unevenness appearson LCD monitor screen.

Is input image copy-guarded?

Is the disc write-protected or the card locked?

Is disc scratched or does dirt or fingerprint adhere to it?

Clean the disc. If there is still no improvement, replace the disc.

Is some other AV device directly connected to the video/audio input/output jack of this DVD video camera/recorder?

If the AV device is connected via several other devices, such as AV selector, the video signal may not be transmitted incorrectly. In such a case, reduce the number of devices through which the video signal is transmitted, or connect AV device directly.

Are you attempting to record image from video game or PC? From some video games or PCs, image cannot be recorded on this DVD video camera/recorder.

Has brightness of LCD screen been adjusted?

Stop recording and adjust the brightness.

Is the DVD video camera/recorder being used outdoors?

Use the viewfinder. When using LCD monitor, adjust its angle so that LCD screen is not exposed to direct sunlight.

Is it difficult to use auto focus with your subject?

Focus manually.

Does "MF" appear?

The DVD video camera/recorder is set to manual focus. Focus the subject manually, or release manual focus.

Is the diopter control correctly adjusted if you are using the viewfinder as a monitor?

Adjust the diopter control.

In cases other than the above, set the power switch to "OFF", and then set it to "411", "1_1" or "lt_" again.

Repair is only possible when the DVD video camera/recorder is

powered by the AC adapter/charger. Remove the disc, and then insert another disc: The removed disc can later be repaired by connecting the AC adapter/charger.

Did you press the LCD monitor or the area around it?

If the LCD monitor is pressed, some unevenness will occur. Release your hand and leave the LCD monitor for a while: Normal display witl be restored.

27, 8I, I33,

I58

5I

80

80

98

35, 36

73

72

36

44

43

168

Page 168
Image 168
Hitachi DZ-MV780A instruction manual 168, Dvd