Hitachi DZ-MV780A Turning DVD Video Camera/Recorder On and Off, Set to D, Set to OFF

Turning DVD Video Camera/Recorder On and Off

While holding down tile gray button at the right of power switch, set tile switch according to each recording function:

Set to "OFF":

Tile DVD video camera/ recorder will turn oft\

Set to "D":

To record still on SD memory card

Set to "_":

To record movie on DVD

RAM or DVD R disc

Set to "1_1":

To record still on DVD

RAM disc

PowerONstatus

During playback, set the power switch to "_" or "1_1"when using disc, or set it to "[1_1"when using card.

Turn the switch while holding down the gray button at the right of switch.

Note:

•Once you turn the DVD video camera/recorder on to let it recognize the disc, you can immediately record or play back by turning the DVD video camera/ recorder on again However, if a long time has elapsed after the disc was inserted, it will take some time for the DVD video camera/recorder to start

because it must recognize the disc again (see page 158)

•It will take some time for the DVD video camera/ recorder to display the Disc Navigation screen after power is turned on

•If you turn the DVD video camera/recorder on, the ACCESS indicator wilt light or blink to show that the DVD video camera/recorder is recognizing the disc or card: During this time, no operation, such as recording, can be performed

After severaI seconds, the ACCESS indicator will go out, and operating the DVD video camera/recorder wiIt be possible

If the ACCESS indicator does not go out, refer to "Check 4" on page 158

ACCESS/PC indicator

•When the DVD video camera/recorder is turned on, the self-diagnosis function will work and a message may appear In this case, refer to "Trouble Messages" on page 160 and take corrective action

•While the ACCESS/PC or CARD ACCESS indicator is

lit or blinking, do not violently open or close the LCD monitor

Power switch

44