Hitachi DZ-MV780A Setting Up Record Functions, Switching Movie Quality Video Mode

Setting Up Record Functions

SWITCHING MOVIE QUALITY (VIDEO MODE)

Choose tile movie quality h_om "XTRA", "FINE", "STD".

1Press the MENU

hutton, use "Operating Menu" (p. 64) to choose "VIDEO Mode" on tile "Record Functions

Setup" inenu screen, and then press tile I_/ button.

2Choose the desired quality mode, and then press the I_/ button.

Note:

•The movie quality setting will be stored in memory even when the DVD video camera/recorder is turned

off.

•The "VIDEO Mode" setting witl not change even if the disc is replaced.

•When using DVD-R disc, you cannot switch the setting on movie quatity or wide-screen mode while recording on the disc: The DVD video camera/ recorder will be automatically set to the movie quality or wide-screen mode first used with the disc for

recording.

• The movie quality setting is effective onty during

3 Press the MENU button to end the setting.

movie recording: The setting will not be displayed during recording of stills.

Movie qua	_	8:ooam
		_,_0,_..5

Block like noise may appear in recorded image, or the outline of subject image is distorted under the

recording conditions listed below: Pan the DVD video camera/recorder as slowly as possible. (Block noise is likely to appear in the "STD" mode):

•If there is a complicated pattern in background (as in following figure on left)

•If the DVD video camera/recorder is moved excessively or quickly

•If suloject is moving rapidly even when the DVD video camera/recorder is not moving

(Image when block-like noise occurs) (Image without block-like noise)

91