Hitachi NJI-350B manual Baud rate Value

TRNS 0 (d, s, t)

Chapter 5 Instruction specifications

[3]Address of sending area :

Address number and address type are configured in 2 words as below.

s+4	Type : WR → H000A
	WM → H000C
s+5

I/O No.: H0000 -

[4]Reserved data size for data sending. : This is not actual data size but reserved size. Set it by "Word".

[5]Address of receiving area :

Address number and address type are configured in 2 words as below. (Data format is as same as sending area.)

[6]Reserved data size for data receiving. : This is not actual data size but reserved size. Set it by "Word".

[7]*1	Receiving data length :
	If receiving data is found by data length, set this parameter by "Byte". The maximum size is 1,024 byte. If data is
	more than 1,024 bytes or reserved area, TRNS command fails with DER="1".
[8]*1	Start code :
	If receiving data is found by start code, set this parameter.
	b15	b7	b0

Start code (H00 - HFF)

=0 : Start code disabled.

=1 : Start code enabled.

[9]*1 End code :

If receiving data is found by end code, set this parameter.

b15 b7 b0

End code (H00 - HFF)

= 0 : End code disabled.

= 1 : End code enabled.

[10] Communication speed :			[11] Communication format
	Baud rate	Value		Format	Value
	300 bps	H0000		7 bits, even parity, 2 stop	H0000
	600 bps	H0001		7 bits, odd parity, 2 stop	H0001
	1,200 bps	H0002		7 bits, even parity, 1 stop	H0002
	2,400 bps	H0003		7 bits, odd parity, 1 stop	H0003
	4,800 bps	H0004		8 bits, non parity, 2 stop	H0004
	9,600 bps	H0005		8 bits, non parity, 1 stop	H0005
	19,200 bps	H0006		8 bits, even parity, 1 stop	H0006
	38,400 bps	H0007		8 bits, odd parity, 1 stop	H0007
	57,600 bps	H0008

5-116