Hitachi NJI-350B Programming Methods, System configuration using a personal computer, Editor

Chapter 7 Programming

7.3 Programming Methods

The following shows the system configuration using a personal computer and the procedures for creating a user program using personal computer software. Please note that cables differ depending on the personal computer and software used.

Table 7.3 System configuration using a personal computer

No.	Personal computer	DOS/V PC	PC9800 series personal computer
	software used
1	LADDER EDITOR
	(Windows version)

		Install				Install
		LADDER EDITOR for				LADDER EDITOR for
	DOS/V PC				PC9800 series PC	Windows® (HLW-PC3)
		Windows (HLW-PC3,				system disks (Japanese)
	(Windows 95/98/NT)	HLW-PC3E) system disks			(Windows® 95/98/NT)
		(Japanese, English)
CPU setting				Specify H-302.
Memory assignment			Specify RAM-04H (4 K memory).
Cable (MICRO-EH side)	EH-RS05		EH-VCB02			EH-RS05
Cable	WVCB02H					WPCB02H
(personal computer side)

Port 1 *1, *2

10-point type	There are no DIP switches (fixed to 4800 bps).
	DIP SW	1	2	3	4
		ON	OFF	ON	OFF	38.4 kbps
14/23/28-point type	Status	ON	OFF	OFF	OFF	19.2 kbps	Same as left
		OFF	OFF	ON	OFF	9600 bps
		OFF	OFF	OFF	OFF	4800 bps

		10/14-point type	Port 2 does not exist.
	Port 2		Cannot be connected with the above configuration since the RS-422/485 are used (RS-
		23/28-point type	232C/422 converters are required.)
			Set the transmission speed in the special internal output (WRF03D).
2	LADDER	EDITOR
(DOS version)

					Install					Install
					LADDER EDITOR DOS					LADDER EDITOR
		DOS/V PC			version (HL-AT3E)				PC9800 series	DOS version (HL-PC3)
		(MS-DOS®)			system disks (English)				PC (MS-DOS®)	system disks (Japanese)
CPU setting								Specify H-302.
Memory assignment							Specify RAM-04H (4 k memory).
Cable (MICRO-EH side)				EH-VCB02						EH-RS05
Cable										PCCB02H
(personal computer side)
Port 1	10-point type	There are no DIP switches (fixed to 4800 bps).
		DIPSW	1		2	3	4
*1, *2	14/23/28-point type								Same as left
		Status	OFF		OFF	OFF	OFF	4800 bps

Port 2

10/14-point type	Port 2 does not exist.
	Cannot be connected with the above configuration since the RS-422/485 are used (RS-
23/28-point type	232C/422 converters are required.)
	Set the transmission speed in the special internal output (WRF03D).

*1: Settings of the port 1 can be changed when the DR signal is off. When the DR signal is on, the setting is fixed.

*2: Set the port 1 to the transmission control procedure 1 by the special internal output (WRF01A). (The default is the transmission control procedure 1.)

Note: Refer to the manual of the applicable software on how to install and operate each software (LADDER EDITOR).

7-3