Honeywell K14114 3/06 Rev.B Connecting AlarmNet 7845CV2, LYNXR-IInstallation and Setup Guide

LYNXR-I Installation and Setup Guide

LRR/IP Communications Device 24-Hour Standby Power

If you are installing the AlarmNet 7845GSM/7845i-GSM or 7845i-L you must install the Super High Capacity battery P/N!WALYNX-RCHB-SHA in the LYNXR-I.

The 7845i-ENT/7845i and 7845CV2 can not be used for installations requiring 24-hour standby.

AlarmNet 7845CV2

1.Connect the 4-wire communications cable to the LRR/IP communications port on the LYNXR-I.

2.Connect the four wires to the 7845CV2 as shown below:

4-WIRE CABLE (N4632-4)

BATTERY

ADEMCO

K4362

YEL RED BLK GRN

						RED
					LRR/IP COMMUNICATIONS PORT
OUTDATA	NC	VDC+12	GND	DATAIN
						BLK
						YEL
						GRN

LYNXR-I CONTROL PANEL

LYNX

STANDARD

CAPACITY

BATTERY

Connecting AlarmNet 7845CV2

P1 BAT

V+

GND

Z1/DATA IN

RAD FLT/ DATA OUT

TB1

7845CV2

07000-011-V2

Configuring Long Range Radio and Internet Communication Devices

1.Enable the communications device in programming field *55 and configure alarm reporting and module supervision in programming field *77.

2.Program the device as required using the 7720P programmer (refer to the Installation Instruction for the device that you are installing for additional information). Note that the device address must be set to 3.

1.When programming an AlarmNet 7845CV2 the radio’s “current limit” most option must be set to [Y] (yes).

2.The device must be registered before downloading or alarm reporting can take place.

- 10 -