Honeywell K14114 3/06 Rev.B setup guide Remote Phone Control Feature, Speaker Phone Operation

LYNXR-I Installation and Setup Guide

System Operation

To use the defined AUX function: Press and hold AUX key 2 secs (4 beeps) +

To define AUX function:	+			+		+ action separated by +
		FUNCTION			AUX		AUX
AUX
To send message to pager: Press and hold			key 2 seconds (4 beeps)
		AUX

To program Follow Me Announcement telephone number: + FUNCTION

terminated by +

+ [65]

AUX

+

Speaker Phone Operation			NOTE
To place a call or answer a call using the speaker phone: [#] +			The ARMED and READY LEDs blink
		AUX
To flash (switch between two calls using call waiting):			alternately when the Speaker Phone is
	AUX		active.

To hang up and exit speaker phone mode: OFF

To enable/disable (toggle) ringer: [#] + VOLUME + AUX

To return the keypad to telephone mode after disarming the system: [#] + AUX

Remote Phone Control Feature

The remote phone control feature, which must be enabled in field ✻91, allows the user to access the security system from any off-site touch-tone telephone. The control will pick up the incoming call, based on the ring count specified in field ✻95, and will announce “SYSTEM ENTER CODE” every three (3) seconds for the next eight (8) seconds. During this period the panel will wait for a valid User Code to be entered. If a valid User Code is not entered or the eight (8) second period expires a modem tone will be generated for remote programming (Compass Downloading). If a valid User Code has been entered, the control will announce the current system status and/or beeping sounds.

Keypad Functions			Quick Arm Note
Remote Phone Control Feature			The installer code and
			babysitter code cannot
To remotely disarm system:	+ [1]
			disarm	the	system if
To remotely arm in AWAY mode:	+ [2]		armed	by	Quick Arm
			method.
To remotely arm in STAY mode:
	+ [3]
To remotely arm in AWAY or STAY with no delay:		+ [2] or [3] + [0]
To remotely activate X10 devices 1-6:[#] + [4] + device no.
To remotely activate X10 devices 7 & 8:		+ [#] + [4] + device no.
To remotely deactivate X10 devices 1-6:[#] + [7] + device no.
To remotely deactivate X10 devices 7 & 8:		+ [#] + [7] + device no.
To remotely Bypass zones:	+ [6] + zone no.
To remotely activate Forced Bypass:	+ [6] + [#]
To remotely check system status: [✻]
To end remote phone control session: Hang Up or enter		+ [9]

- 52 -