Honeywell K14114 3/06 Rev.B Loop number or Loop and Serial, Delete zone parameters confirmation

			LYNXR-I Installation and Setup Guide
		56 Enhanced Zone Programming Mode
		✻
		Loop number or Loop and Serial	This prompt can be used to enroll loop number and serial number via
E
	l	number (if using RF Learning)	RF transmission or the loop number can be enrolled manually. If
			using the RF Learning Mode, there is no need to manually enter a
		1-4 = loop number for the zone of the transmitter
			loop number. Proceed directly to RF Learning
		being entered.
		0 + [✻] = continue to DELETE ZONE	Notes: (1) BR type devices cannot be enrolled by using UR or RF
		PARAMETERS CONFIRMATION prompt	type. Likewise, UR or RF type devices cannot be enrolled
		(F)	by using a BR type device. There is a 52-second time-out
		[✻] = continue to the ENROLL MODE prompt	for RF enrolling. At the end of the time-out, the system
		(1A) if not entered, or VOICE DESCRIPTOR	returns to the INPUT TYPE prompt (d). If enrolled, loop
			number and “L” are displayed.
		prompt if already entered
			(2) Once encrypted (high-security) devices have been enrolled
		[#] = return to previous prompt
			they must be activated. Refer to the device’s Installation
			Instructions to activate the High-Security Mode. RF
			Learning - Two (2) transmissions (2 key depressions) at
			least 5 seconds apart will be required for BR type devices
			(device type 5). Two beeps will sound after the second
			transmission, confirming that the loop number and serial
			number have been learned.
			For all other device types, four (4) transmissions are required (fault,
			restore and fault, restore). A single beep will sound after the second
			transmission confirming that the loop and serial number have been
			captured. Following the fourth transmission the system will confirm
			that the loop number and serial number have been learned and
			announce the Voice Descriptor for the zone, if it is programmed,
			followed by two beeps.
			Press [✻] to continue.
			Manual Entry - Enter the desired loop number and press [✻] to
			continue (see the transmitter’s Installation Instructions for specific
			loop designations).
			Note: The loop number can be changed even if the zone has already
			been entered. Care should be taken when using this feature as
			it has the capability to make zones inoperable by creating a
			mismatch of a working serial number/loop number
			combination. This should be re-confirmed if the loop number is
			changed.
			“L” indicates that the zone’s serial number has already been enrolled.
		Delete zone parameters confirmation	This function deletes either the serial number or all zone information
F
		0 = discard the delete request	that is programmed for the zone.
			If “00” was entered in the zone type, the confirmation of the delete
		1 = confirm requested delete
			request will delete all information associated with the zone currently
		Note: If 00 was entered as a zone type in prompt (b), 00	being programmed.
		will be retained and system will advance to	If “0” was entered in the loop number, the confirmation of the delete
		prompt (1C).
			request will delete the serial number of to the zone currently being
			programmed.

- 31 -