Honeywell K14114 3/06 Rev.B setup guide Connecting AlarmNet 7845GSM* / 7845i-GSM

LYNXR-I Installation and Setup Guide

AlarmNet! 7845GSM*, 7845i-GSM*, 7845i-ENT or 7845i, Communications Device

The 7845i-ENT/7845i and 7845CV2 can not be used for installations requiring 24-hour standby.

1.Connect the 4-wire communications cable to the LRR/IP Communications port on the LYNXR-I.

2.Connect the four wires to the specific Communications device as shown in the accompanying figures.

3.If you are installing a 7845GSM or 7845i-GSM you must also install a jumper between terminals 2 and 3 on the communications device.

4.Connect the device to the Internet via a cable/DSL modem and router or to an Intranet (LAN) via the appropriate Ethernet connection, if applicable.

TB1

1

2

RED

YEL

RED BLK

GRN

4-WIRE CABLE (N4632-4)

BLK

43 ECP (+) VOLTAGE INPUT

4 GND

DATA OUT

NC	VDC	GND
	+12

DATA IN

YEL

GRN

LRR/IP COMMUNICATIONS PORT

5 Z1/Z2 OR DATA IN

6 Z3 OR DATA OUT

					LYNXR-I CONTROL PANEL	7845GSM / 7845i-GSM
				LYNX
				STANDARD
				CAPACITY
				BATTERY
	LYNX	HIGH	(OPTIONAL)
SUPER
CAPACITY			REQUIRED FOR
BATTERY			24-HR BACKUP			7845i-GSM-010-V0

Connecting AlarmNet 7845GSM* / 7845i-GSM*

* When available. The AlarmNet 7845GSM and 7845i-GSM modules have not been evaluated by UL.

4-WIRE CABLE (N4632-4)

7845i-ENT / 7845i

YEL	RED	BLK	GRN	(+) VOLTAGE INPUT	GND	DATA OUT	DATA IN
				TB 1

				LRR/IP COMMUNICATIONS PORT
DATA OUT	NC	+12 VDC GND DATA IN
				LYNXR-I CONTROL PANEL
			LYNX
		STANDARD
		CAPACITY
			BATTERY

RED BLK GRN YEL

RED

BLK

GRN

YEL

07000-013-V2

Connecting AlarmNet 7845i-ENT/7845i

- 9 -