HP 200 Unified Threat Management (UTM) Appliance manual Configuring a user privilege level

Table 28 Command levels and user privilege levels

Level	Privilege	Default set of commands
		Includes commands for network diagnosis and commands for accessing an external
0	Visit	device. Configuration of commands at this level cannot survive a device restart. Upon
		device restart, the commands at this level are restored to the default settings.
		Commands at this level include ping, tracert, telnet and ssh2.
		Includes commands for system maintenance and service fault diagnosis. Commands at
1	Monitor	this level are not saved after being configured. After the device is restarted, the
		commands at this level are restored to the default settings.
		Commands at this level include debugging, terminal, refresh, and send.
		Includes service configuration commands, including routing configuration commands
2	System	and commands for configuring services at different network levels.
		By default, commands at this level include all configuration commands except for those
		at manage level.
		Includes commands that influence the basic operation of the system and commands for
		configuring system support modules.
3	Manage	By default, commands at this level involve the configuration commands of file system,
		FTP, TFTP, Xmodem download, user management, level setting, and parameter settings
		within a system, which are not defined by any protocols or RFCs.

Configuring a user privilege level

If the authentication mode on a user interface is scheme, configure a user privilege level for the user interface's users through the AAA module or directly on the user interface. For SSH users who use public-key authentication, the user privilege level configured directly on the user interface always takes effect. For other users, the user privilege level configured in the AAA module has priority over the one configured directly on the user interface.

If the authentication mode on a user interface is none or password, configure the user privilege level directly on the user interface.

For more information about user login authentication, see "Logging in to the CLI." For more information about AAA and SSH, see Access Control Configuration Guide.

Configuring a user privilege level for users through the AAA module

Step		Command	Remarks
1.	Enter system view.	system-view	N/A
2.	Enter user interface	user-interface { first-num1
		[ last-num1] { console vty }	N/A
	view.
		first-num2 [ last-num2 ] }
3.	Specify the scheme		By default, the authentication mode for
		authentication-mode scheme	VTY users is scheme, and no
	authentication mode.		authentication is needed for console
			login users.
4.	Return to system view.	quit	N/A

133