HP 6120 Error Messages, Figure 10-6.Example of the Custom show interfaces Command

Port Status and Configuration

Viewing Port Status and Configuring Port Parameters

ProCurve(config)# show int custom 1-4 port name:4 type vlan intrusion speed enabled mdi

Status and Counters - Custom Port Status

Port Name		Type	VLAN	Intrusion	Speed	Enabled MDI-mode
				Alert
---- ----------		----------	-----	---------	-------	------- --------
1	Acco	100/1000T	1	No	1000FDx	Yes	Auto
2	Huma	100/1000T	1	No	1000FDx	Yes	Auto
3	Deve	100/1000T	1	No	1000FDx	Yes	Auto
4	Lab1	100/1000T	1	No	1000FDx	Yes	Auto

Figure 10-6. Example of the Custom show interfaces Command

You can specify the column width by entering a colon after the column name, then indicating the number of characters to display. In Figure 10-6 the Name column only displays the first four characters of the name. All remaining characters are truncated.

N o t e	Each field has an fixed minimum width to be displayed. If you specify a field
	width smaller than the minimum width, the information is displayed at the
	minimum width. For example, if the minimum width for the Name field is 4
	characters and you specify Name:2, the Name field displays 4 characters.
	Parameters can be entered in any order. There is a limit of 80 characters per
	line; if you exceed this limit an error displays.
	Error Messages
	Error	Error Message
	Requesting too many fields (total characters	Total length of selected data exceeds one line
	exceeds 80)
	Field name is misspelled	Invalid input: <input>
	Mistake in specifying the port list	Module not present for port or invalid port:
		<input>
	The port list is not specified	Incomplete input: custom

10-12