HP 6120 snmpv3 group, SNMPv3 Group Commands, Assigning Users to Groups, Figure 13-3.Example of Assigning Users to Groups

Configuring for Network Management Applications

Using SNMP Tools To Manage the Switch

Assigning Users to Groups. Then you must set the group access level for the user by assigning the user to a group. This is done with the snmpv3 group command. For more details on the MIBs access for a given group refer to “Group Access Levels” on page 13-12.

Add NetworkAdmin to operator noauth group

Add NetworkMgr to managerpriv group

Pre-assigned groups for access by Version 2c and version 1 management applications

Figure 13-3. Example of Assigning Users to GroupsSNMPv3 Group Commands

Syntax: [no] snmpv3 group

This command assigns or removes a user to a security group for access rights to the switch. To delete an entry, all of the following three parameters must be included in the command.

group <group_name>

This parameter identifies the group that has the privileges that will be assigned to the user. For more details refer to “Group Access Levels” on page 13-12.

user <user_name>

This parameter identifies the user to be added to the access group. This must match the user name added with the snmpv3 user command.

sec-model <ver1 ver2c ver3>

This defines which security model to use for the added user. A SNMPv3 access Group should only use the ver3 security model.

13-11