HP 6120 PC or UNIX Workstation

	File Transfers
	Downloading Switch Software
	The Bad file number is from the system error value and may differ
N o t e
	depending on the cause of the failure. In the third example, the device file to
	read was closed as the device read was about to occur.
	Attempt to Start a Session During a Flash Write. If you attempt to
	start an SCP (or SFTP) session while a flash write is in progress, the switch
	will not allow the SCP or SFTP session to start. Depending on the client
	software in use, the following error message may appear on the client console:
	Received disconnect from 10.0.12.31: 2: Flash access
	in progress
	lost connection
	Failure to Exit from a Previous Session. This next example shows the
	error message that may appear on the client console if a new SCP (or SFTP)
	session is started from a client before the previous client session has been
	closed (the switch requires approximately ten seconds to timeout the previous
	session):
	Received disconnect from 10.0.12.31: 2: Wait for
	previous session to complete
	lost connection
	Attempt to Start a Second Session. The switch supports only one SFTP
	session or one SCP session at a time. If a second session is initiated (for
	example, an SFTP session is running and then an SCP session is attempted),
	then the following error message may appear on the client console:
	Received disconnect from 10.0.12.31: 2: Other SCP/SFTP
	session running
	lost connection
	Using Xmodem to Download Switch Software From a
	PC or UNIX Workstation
	This procedure assumes that:
	■ The switch software is stored on a disk drive in the PC.
	■ The terminal emulator you are using includes the Xmodem binary transfer
	feature. (For example, in the HyperTerminal application included with
	Windows NT, you would use the Send File option in the Transfer dropdown
	menu.)

A-19