HP 6120 Custom” Command, Viewing Port Utilization Statistics, Note on Using Pattern Matching with the “Show Interfaces, include, show interface, show int custom

Port Status and Configuration

Viewing Port Status and Configuring Port Parameters

Note on Using Pattern Matching with the “Show InterfacesCustom” Command

If you have included a pattern matching command to search for a field in the output of the show int custom command and the show int custom command produces an error, the error message may not be visible and the output is empty. For example, if you enter a command that produces an error (vlan is misspelled) with the pattern matching include option:

ProCurve(config)# show int custom 1-3 name vlun

include vlan1

the output may be empty. It is advisable to try the show int custom command first to ensure there is output, and then enter the command again with the pattern matching option.

Viewing Port Utilization Statistics

Use the show interface port-utilizationcommand to view a real-time rate display for all ports on the switch. The following shows a sample output from this command.

ProCurve(config)# show interfaces port-utilization

Status and Counters - Port Utilization
Port	Mode	---------------------------	Rx		---------------------------	Tx
			Pkts/sec	Util		Pkts/sec	Util
		Kbits/sec			Kbits/sec
---------B1	-------- + ----------		---------- ----- + ----------			---------- -----
	1000FDx	0	0	0	0	0	0
B2	1000FDx	0	0	0	0	0	0
B3	1000FDx	0	0	0	0	0	0
B4	1000FDx	0	0	0	0	0	0
B5	1000FDx	0	0	0	0	0	0
B6	1000FDx	0	0	0	0	0	0
B7	100FDx	624	86	00.62 496		0	00.49

Figure 10-7. Example of a Show Interface Port-Utilization Command Listing

10-13