HP 8300e D8C26UTABA manual

3.Install guide screws on the sides of the drive. If you are installing a 2.5-inch drive, you must install the drive in an adapter bracket.

NOTE: The hard drive uses 6-32 isolation mounting guide screws. Four extra guide screws are installed on the exterior of the hard drive bays. The HP-supplied isolation mounting guide screws are silver and blue. Refer to Drives on page 135 for an illustration of the extra 6-32 isolation mounting guide screws location.

If you are replacing a drive, transfer the guides screws from the old drive to the new one.

●If you are installing a 3.5-inch hard drive, install four isolation mounting guide screws (two on each side of the drive).

Figure 7-22Installing Isolation Mounting Guide Screws in a 3.5-inch Drive

●If you are installing a 2.5-inch hard drive:

◦Install four 6-32 silver and blue isolation mounting guide screws in the adapter bracket (two on each side of the bracket).

◦Install the drive into the slot on the adapter bracket with the PCA side facing down, aligning the three tabs on the bracket with the drive. Ensure that the power and data connectors on the drive are properly oriented.

Figure 7-23Installing the Drive in the Adapter Bracket

◦Hold the drive and bracket firmly together and turn the assembly over. Install four M3 screws to secure the drive to the bracket.

142 Chapter 7 Removal and Replacement Procedures Microtower (MT) Chassis