HP 8300e D8C26UTABA manual Solving Memory Problems, New network card will not boot Cause Solution

Table 10-12Solving Network Problems (continued)

Network controller stopped working when an expansion board was added to the computer.

Cause	Solution
The network controller requires drivers.	Verify that the drivers were not accidentally deleted when the
	drivers for a new expansion board were installed.
The expansion board installed is a network card (NIC) and	Under the Computer Setup Advanced menu, change the
conflicts with the embedded NIC.	resource settings for the board.

Network controller stops working without apparent cause.

Cause	Solution
The files containing the network drivers are corrupted.	Reinstall the network drivers, using the Recovery Disc Set
	created from the hard drive's Recovery Partition.
The cable is not securely connected.	Ensure that the cable is securely attached to the network
	connector and that the other end of the cable is securely
	attached to the correct device.
The network controller is defective.	Contact an authorized service provider.
New network card will not boot.
Cause	Solution

New network card may be defective or may not meet industry-standard specifications.

Install a working, industry-standard NIC, or change the boot sequence to boot from another source.

Cannot connect to network server when attempting Remote System Installation.

Cause Solution

The network controller is not configured properly.

Verify Network Connectivity, that a DHCP Server is present, and that the Remote System Installation Server contains the NIC drivers for your NIC.

System setup utility reports unprogrammed EEPROM.

Cause	Solution
Unprogrammed EEPROM.	Contact an authorized service provider.

Solving Memory Problems

If you encounter memory problems, some common causes and solutions are listed in the following table.

280 Chapter 10 Troubleshooting Without Diagnostics