HP 8300e D8C26UTABA manual

b.Press the tab on right side of the panel (1), and then swing the right side of the cage away from the chassis to remove it (2).

Figure 9-35Removing the I/O panel

12.Remove the three remaining Torx T15 screws (1) that secure the system board to the chassis.

13.Slide system board toward the front of the unit until the rear connectors are clear of their slots in the chassis (2).

14.Lift the rear of the system board until it clears the chassis, and then remove the system board from the chassis (3).

Figure 9-36Removing the system board

To install the system board, reverse the removal procedure.

NOTE: When replacing the system board, you must also change the chassis serial number in the BIOS.

System Board 239