Installing a
1.Prepare the computer for disassembly (Preparation for Disassembly on page 72).
2.Remove the computer access panel (Access Panel on page 73).
3.Remove the front bezel (Front Bezel on page 74).
4.If you are installing a drive in a bay covered by a bezel blank, remove the bezel blank. See Bezel Blanks on page 77 for more information.
5.Install four M3 metric guide screws in the lower holes on each side of the drive (1). HP has provided four extra M3 metric guide screws on the
NOTE: When replacing the drive, transfer the four M3 metric guide screws from the old drive to the new one.
CAUTION: Use only
Figure
94 Chapter 6 Removal and Replacement Procedures Convertible Minitower (CMT) Chassis