HP 8559A ALC, MARKERS, RFOFF/ON, POLARITY, SWEEP MODE, Power Meter, POWER LEVEL, SENSITIVITY, Synchronizer, Powersplitter, Sweep Oscillator, 20 dB Attenuator

MODEL 8559A	ADJUSTMENTS
ADJUSTMENTS
5-28. FREQUENCY RESPONSE ADJUSTMENTS(Cont'd)
EQUIPMENT:
Sweep Oscillator .........................................................	HP 8620C
RF Plug-In (.01- 2.4 GHz) ..............................................	H P 8622A/B
RF Plug-In (2 - 22 GHz) .............................................	H P 86290B-H08
Synchronizer ........................................................	H P 8709A-H10
Power Meter ...........................................................	HP 435A/B
Power Sensor (.Ol - 18 GHz) ..............................................	H P 8481A
Power Sensor (.05 - 26.5 GHz) .............................................	H P 8485A
Crystal Detector (-01-26.5 GHz) ..........................................	HP 33330C
20 dB Attenuator ..............................................	H P 8491B, Option 020
Tuning Voltage Circuit ............................................	Refer to Figure 5-17
Cable,SMA(m)toSMA(m) ...........................................	HP8120-1578
Cable, BNC (m) to SMC (f) ...........................................	H P 11592-60001
Adapter, Type N (m) to SMA (f) (2 required) ...............................	H P 1250-1250
Adapter, Type N (f) to SMA (f) (2 required) ................................	H P 1250-1745
Adapter, Type N (f) to Type N (f) ........................................	H P 1250-1472
Extender Cable Assembly ..............................................	H P 5060-0303
Powersplitter .........................................................	11667A-C16

PROCEDURE:

1.Allow one-half hour warmup time of equipment with analyzer connected to mainframe with extender cable.

2.Connect equipment as shown in Figure 5-16 with power meter/power sensor connected to 20 dB attenua- tor and H P 86222A/B (.01- 2.4 GHz plug-in) installed in sweep oscillator mainframe.

3.Set sweep oscillator controls as follows:

Mainframe:
SWEEP MODE ..............................................................	EXT
MARKERS .................................................................	OFF
All rear panel switches .........................................................	OFF
Plug-in
RFOFF/ON .................................................................	OFF
ALC .......................................................................	EXT
POWER LEVEL .......................................................	Fully CCW
FM/NORM/PL (rear-panel) .....................................................	PL
4. Set synchronizer controls as follows:

POLARITY ...................................................................	-
SENSITIVITY .......................................................	6 MHz/VOLT