MODEL 8559A

INSTALLATION AND OPERATIONVERIFICATION

SECTION II

INSTALLATION AND OPERATION VERIFICATION

2-1. INTRODUCTION

2-2. This section includes information on initial inspection, preparation for use, and storage and shipping requirements for the HP 8559A.

2-3.INITIALINSPECTION

2-4. Inspect the shipping container for damage. If the shipping container or cushioning material is dam- aged, it should be kept until the contents of the shipment have been checked for completeness and the instrument has been checked mechanically and elec- trically. The contents of the shipment should be as shown in Figure 1-1. The electrical performance is checked by the Operation Verification procedure in this section. If the contents are incomplete, or if the instrument does not pass Operation Verification tests, notify the nearest Hewlett-Packard office. If the shipping container is damaged, or the cushioning material shows signs of stress, notify the carrier as well as the Hewlett-Packard office. Keep the shipping materials for carrier's inspection. The HP office will arrange for repair or replacement without waiting for claim settlement.

2-5. PREPARATIONFOR USE2-6. Installation

2-7. When properly installed, the spectrum analyzer obtains all necessary power from the display mainframe. The rear panel connector provides the interface.

BEFORE SWITCHING ON THIS INSTRUMENT, make sure it is adapted to the voltage of the ac power source to be used and the proper fuse is installed. Failure to set the ac power input of the instrument for the correct voltage level could cause damage to the instrument when plugged in. Refer to the display mainframe Operation and Service Manual for line voltage and fuse selection.

2-8. To install the spectrum analyzer in the main- frame:Set display mainframe LINE switch to OFF.

Pull out lock knob and slide plug-in toward rear of compartment until it is seated firmly in place.

Push in lock knob to secure spectrum analyzer in mainframe.Side Stop Kits

2-10. Side stops unique to the installation of this instrument into the HP 853A Spectrum Analyzer Display are included with the HP 853A. Refer to the HP 853A Operation and Service Manual for further information.

2-11. Installation of a Side Stop Kit, H P Part Number 08558-60131, prevents the removal of the analyzer from the HP 180-series mainframe without the use of hand tools. This kit contains two side stops, mounting hardware, label, and installation instructions. (Refer to Table 2-1 for part numbers of individual items.)

TABLE 2-1. SIDESTOPKIT (0855860131)

Quantity

Description

I

HPPart

I I

 

Number

 

SIDE STOP

MACHINE SCREW,

4-40, ,438 IN-LG

82 DEG FLATHEAD

LABEL, FRONT-PANEL LABEL, INSTRUCTIONS