HP 8559A manual 24

GENERAL INFORMATION				MODEL 8559A
		TABLE 14. RECOMMENDED TEST EQUIPMENTQOF 4)
	Instrument	Critical Specifications	Recommended	Use*
			Model
	Fixed Attenuator	Frequency Range: 10 MHz t o 18 GHz	HP 8491B
	(2 required)	Attenuation: 20 dB + I .O dB	Option 0206
		Connectors: Type N (m) ( f )
	Fixed Attenuator	Frequency Range: 10 MHz t o 18 GHz	HP 8491B
		Attenuation: 10 dB +0.5 dB	Option 0106
		Connectors: Type N (m) ( f )
	Crystal Detector	Frequency Range: 10 MHz to 21 GHz	HP 33330C
		Frequency Response: t 0 . 6 dB, .O1 to 18 GHz
		Maximum SWR: G1.5, .O1 to 18 GHz
		Output Polarity: Negative
		Connectors:
		APC -3.5 (SMR) (m) input, SMC (m) output
	Termination	Frequency Range: 1 0 MHz to 18 GHz	HP 909A
		Impedance: 5052	Option 0 1 2 ~
		Connector: Type N (m)
	Tuning Voltage Circuit	Refer to Figure 5-17	None
	Crystal Bypass Networks	Refer to Figure 5-6	None
	Special Extender Board	Refer to Figure 5-9	None
	Extender Cable	Extends Spectrum Analyzer Plug-In for Servicing	HP 5060-0303
		Refer to Figure 1-3.
	Cable	Frequency Range: 10 MHz to 21 GHz
		Maximum SWR: G1.4 at 21 GHz
		Length: 6 1 cm (24 inches)
		Connectors: SMA (m) both ends
	Cable	BNC (m) to SMC (f), 3 6 inches long
	Cable	48 inch, 50!2 coaxial cable with BNC (m)
		connectors on both ends (3 required)
	Cable	RG-214/U with Type N connectors (2 required)
	Cable	BNC (m) to Banana Plug
	Test Cable	Connectors: BNC (m) t o SMB (f)
		Length: >61 cm (24 inches)

*P = Performance Test; A = Adjustments; T = Troubleshooting Option number specifies attenuation value.

Option 012 provides type N male connector.