To install MS-DOS, To install Windows for Workgroups

Using Windows for Workgroups 3.11

Installing Windows for Workgroups 3.11

To install MS-DOS

This section is not intended to replace your MS-DOS Documentation. Please refer to your MS-DOS documentation for specific instructions.

1.Insert the MS-DOS Setup Disk 1.

2.Turn on the computer or press Ctrl+Alt+Del to reboot.

3.Press Enter at the MS-DOS Welcome screen.

4.Enter the requested information or press Enter to accept the defaults.

5.Follow the instructions as they appear.

6.Reboot when prompted.

This section is not intended to replace your Windows documentation. Please refer to your Windows documentation for specific instructions.

1. Insert the Windows Setup Disk 1.

2. Type A:\SETUP at the MS-DOS prompt.

3. Follow the instructions as they appear.

Important	If you are installing Windows for Workgroups, do not install networking at this
	time. Follow the instructions in the application note for the network card you are
	using. Application notes are available on our website at:
	http://www.hp.com/go/omnibook .
	4.	Return to MS-DOS when prompted.
	4.	Return to MS-DOS when prompted.
	5.	At the MS-DOS prompt type EDIT C:\CONFIG.SYS.
	6.	Replace the line:
		DEVICE=C:\WINDOWS\HIMEM.SYS
		with the lines:
		DEVICE=C:\DOS\HIMEM.SYS /MACHINE:2 /TESTMEM:OFF
		DEVICE=C:\DOS\EMM386.EXE NOEMS X=D000-D1FF
	7.	Save and exit the MS-DOS Editor.

2-4