LED | Description |
|
|
If you press the Cancel button for 0.5 second in Ready mode, this LED lights and the Toner Save mode is enabled.
If you press this button once again, this LED turns off and the Toner Save mode is disabled.
If the Online/Error and Toner Save LEDs blink, your system has some problem. To solve the problem, see “Troubleshooting Error Messages” on page 6.21.
1
Cancel button
Function | Description | |
|
| |
Printing demo page | In Ready mode, press and hold this button for about 2 | |
| seconds until all LEDs blink slowly, and release. | |
|
| |
| In Ready mode, press and hold this button for about 6 | |
Printing configuration | seconds until all LEDs blink fast, and release. | |
If your printer has a network card, the network | ||
sheets | ||
configuration sheet prints out with a printer | ||
| ||
| configuration sheet. | |
|
| |
Network card Default | In Ready mode, press and hold this button for about | |
Setting (When you use the | 20 seconds until all LEDs blink slowly, and release. | |
Network card) | This item restores the factory default of the network | |
| configuration. This setting will only take effect after | |
| you have reset the printer. | |
|
| |
Manual Feeding | Press this button each time you load paper in the | |
| ||
| Feed for Source from your software application. For | |
| detailed information, see “Using the Manual Feed | |
| Mode” on page 3.12. | |
|
| |
Cleaning inside printer | In Ready mode, press and hold this button for about | |
| 10 seconds until all LEDs turn on, and release. After | |
| cleaning the printer, one “cleaning sheet” (see | |
| page 5.7) is printed. | |
|
|
INTRODUCTION 1.7
