HP D3604-90004 manual Setting Scsi Addresses, Storage System Switch Location

2 Cabling Storage Devices and Setting SCSI Addresses

Setting SCSI Addresses

The following is a description of the switch settings on the rear of the hot-swap subsystem cage (see Figure 2-1). The default switch setting is described in the “Cabling Configurations” section of this chapter.

NOTE The numbers on the front bezel simply denote the position of the disk module in relation to the hot-swap subsystem. These numbers are not related to the SCSI addresses.

Switches 3, 4 and 6 determine the SCSI address of the hot-swap shelf, as shown in Figure 2-2.

Off

On

1

2

3

4

5

6

1

2

3

4

5

6

UPPER CAGE

LOWER CAGE

Figure 2-2. Storage System Switch Location

14