HP D3604-90004 manual Removing a Hot-Swap Disk Module, Installing the Hot-Swap Disk Module

3 Installing Hardware Accessories

E nglish

Figure 3-2. Installing the Hot-Swap Disk Module

Removing a Hot-Swap Disk Module

This section describes the process for removing a hot-swap disk module.

CAUTION The module may be spinning and may be warm to touch.

Complete the following procedure to remove a disk module:

1.Verify the hot-swap disk module keylock is unlocked, and unlock the hot- swap disk module by pushing the locking tab down and lifting the front lever.

2.Support the bottom of the module as shown in Figure 3-3. Slowly pull the module straight out. Do not allow the hot-swap disk module to fall.

27