HP D3604-90004 36

3 Installing Hardware Accessories

NOTE Do not dispose of the blank filler panel. If you decide to operate the storage system with an empty bay, it must be covered with a blank filler panel to ensure proper cooling, and compliance with RFI and safety standards.

6.Mount the device in an HP tray if necessary.

7.Configure the device per manufacturer’s instructions.

8.Secure the drive and tray in the SCSI device shelf using the same screws used to attach the filler panel.

9.Attach the SCSI cable for the appropriate configuration. Refer to the “Cabling Configuration” section of this manual for additional information.

10.Attach the power connector to the device.

11.Replace the door and the bezel of the storage system.

12.Reconnect the power cords and cables.

13.Power up the storage system, allowing the drives to spin up to speed.

14.Configure the drive as described in your host system’s user guide.

Contents

HP NetServer Storage System/6 User Guide Notice Audience Assumptions Contents 2 Cabling Storage Devices and Setting SCSI Addresses Contents Page Page 1 Introduction Basic Installation Unpacking the NetServer Storage System/6 Contents of the NetServer Storage System/6 Package Identifying Parts of the NetServer Storage System/6 flashing yellow flashing yellow flashing red Page General Operating Instructions Reset Switch Power Cycling Continuous Operation Temperature Control Hot-SwapDisk Module Care and Relocation Spin Up Using an Uninterruptible Power Supply 2Cabling Storage Devices and Setting SCSI Addresses Opening the Door 2Cabling Storage Devices and Setting SCSI Addresses Setting SCSI Addresses Switch Functions Settings Cabling Configurations External Cabling System or 1.0-MeterCable 2.5-MeterCable Accessory SCSI Port Page Storage System Layout Default Cabling Configuration (Non-Duplex) Duplex Configuration Alternate Non-DuplexConfiguration Alternate Duplex Configuration Page 3 Installing Hardware Accessories Installing Hot-SwapStorage Devices Unpacking a Hot-SwapDisk Module Installing a New Hot-SwapDisk Module Removing a Hot-SwapDisk Module Page Installing a SCSI Device in a SCSI Device Shelf Page 4 Troubleshooting Troubleshooting Procedures If The System Will Not Power On If the LED Readout Shows a Fan Fault (FF) If the LED Readout Shows a Line Fault (LF) If the LED Readout Shows a Power Supply Fault (PF) If the SCSI Devices Fail to Spin Up If the Host Cannot Communicate With the Storage System If the Hot-SwapDisk Power LEDs are Flashing Error Messages Troubleshooting Tools Page Page 5 Service and Support Service System Design, Integration and Support Information and Support When You Need It HP NetServer Information Assistant HP Support Assistant CD-ROM CompuServe Discussion Forum and Library World Wide Web and Internet FTP Bulletin Board System Automated Fax HP NetServer Support News Telephone Support Obtaining HP Repair and Telephone Support Ordering HP Cables, Drive Trays and Manuals Ordering System Documentation Ordering HP Cables, Drive Trays and Technical Publications Contacting HP Regional Headquarters Joining CompuServe CompuServe CompuServe Europe Page 6 Warranty and Software License NetServer Storage System/6 On-SiteLimited Warranty Three Year On-SiteLimited Hardware Warranty Page Warranty start date Equipment location Parts covered sold as component mechanisms Non-HP products Travel restrictions and response time Customer Responsibilities Software Product Limited Warranty 6Warranty and Software License Notice of Warranty Claims A Specifications Environment Weight and Dimensions Power Supply Specifications Page B Regulatory Information Notice for USA: FCC Statements Class B Product Statement Country Notices Notice for Canada: DOC Requirements Notice for Germany: Noise Declaration and Ergonomics Notice for U.K.: General Approval Notice for EU: Declaration of Conformity Notice for Japan: VCCI Statement Notice for Korea: RFI Statement Mexico: Hardware Warranty Statement 3. Tiempo de Reparación: 4. Limitaciones: Notas Index Index