![](/images/new-backgrounds/1260106/26010645x1.webp)
Chapter 3 | Hardware Installation and Configuration |
CAUTION The HP TopTools Remote Control card is sensitive to static electricity and can easily be damaged by improper handling. Use of an antistatic service kit, such as 3M® 8501/8502/8505 or equivalent is recommended.
To mount the battery pack:
1.Place the HP TopTools Remote Control card on a clean
2.With reference to Figure
| Cooling vents |
1. Slide battery | 3. Plug battery |
onto board | cable into battery |
| connector. |
2. Insert darts from rear side of board
Figure 3-1. Connecting the Battery Pack and Cables
3.Make sure that the battery pack is securely mounted to the card using two of the supplied plastic darts. These must be pressed in from the back (the circuit side) of the card. The third dart in the package is a spare.
NOTE | In case the battery must be removed (for exchange or |
| replacement), use a screwdriver or a coin to remove the darts. |
|
|
17