Chapter 4Setting Up the Remote Connection

HP TopTools Remote Control for HP NetServers Card Setup <L> LAN Settings

<P> PPP Settings

<R> Remote Boot Settings

<F> Firmware Update Settings

<X> Exit

Figure 4-2. Main Setup Screen

The displayed value on any of the setting screens is updated as soon as an entered value is validated.

LAN Configuration

For a remote connection to the TopTools Remote Control card via LAN, the LAN Settings screen is used to set up the connector on the card. If you are not sure how to set network parameters, contact your network administrator for the correct network settings.

NOTE

The HP TopTools Remote Control card requires its own

 

unique IP address (different from the server’s IP address) since

 

it functions independently of the server on which it is

 

installed.

 

 

Press the desired letter (D, I, N, or G) on the keyboard to change one of your Local Area Network settings. An entry window pops up that allows the entry of the new value. Closing this entry window initializes the validation of the new entry. If it is valid it will be updated on the corresponding setting screen, otherwise an error message occurs. Press M to return to the Main Setup Screen.

HP TopTools Remote Control for HP NetServers - LAN Settings

<D> Enable DHCP

DHCP is DISABLED

<I> Set IP-Address

192.168.10.10

<N> Set

Netmask

255.255.255.0

<G>

Set

Gateway

127.0.0.1

<M>

Main Menu

 

 

 

 

 

Figure 4-3. Local Area Network Configuration

25

Page 31
Image 31
HP D6028-90004 manual LAN Configuration, Setting Up the Remote Connection