Chapter 6 | Setting Up NT Graphics Console Redirection Using pcANYWHERE32 |
To complete configuration of the connection item, proceed to the appropriate section below.
LAN Connection
1.Highlight the TCP/IP option in the list of connection devices and click "Details".
2.Enter Gateway information if necessary, then click OK.
3.Identify the Host PC’s name (or IP Address for the host HP NetServer), then click "Next". If you leave this field blank, pcANYWHERE32 provides a list of available server "Hosts" when you run this connection item. Be sure not to use the HP TopTools Remote Control card’s IP Address.
4.Uncheck "Automatically begin remote control session upon Wizard completion", then click Finish.
5.Optional: To automate login to the host HP NetServer, right click the connection item you just created and click "Properties", then the "Settings" tab. Fill in the "Login information" section.
NOTE | If you intend to access the server through the LAN exclusively, |
| skip the following "Modem Connection" section and proceed |
| to "Finishing Your Connection Items". |
|
|
Modem Connection
1.Highlight an installed modem from the list of connection devices and click Details. Microsoft Windows 95 and NT 4.0 present you with a
2.Check to be sure that the "Maximum speed" field corresponds to the capabilities of the installed modem you selected.
3.Enter the phone number of the HP TopTools Remote Control card’s modem, then click Next.
4.Uncheck "Automatically begin remote control session upon Wizard completion", then click Finish.
48
