F LED Codes

A failure on the HP TopTools Remote Control card is indicated by a flashing signal pattern displayed by the red diagnostic LED visible above the RS-232 port (refer to Figure F-1). The other set of LEDs located next to the LAN port indicate LAN connection activity.

NOTE

In the event that more than one error is affecting card

 

operation, the HP TopTools Remote Control reports only the

 

first failure discovered.

 

 

Diagnostic

LEDs

LAN LEDs

LAN Connector

 

Figure F-1. HP TopTools Remote Control LED

 

 

NOTE

The LEDs mounted on the HP TopTools Remote Control card

 

are unusually small micro devices that, until activated, appear

 

as little white dashes on the circuit board.

 

 

Each failure is stored as a four-digit code. This allows each code up to 10 "sub-codes" that can be interpreted by the diagnostic utility.

91

Page 97
Image 97
HP D6028-90004 manual LED Codes, As little white dashes on the circuit board