Appendix C | Installing and Using TFTP |
where a: is the source diskette and x:\path\filename is the destination drive, path and filename with a .dsk extension for your image file. An image file is created and transferred to the designated directory.
Initiating a Remote Boot Using a Floppy Boot Image
There are two ways to boot the HP NetServer using a remote boot image:
∙Remote Boot Option 1 requires
∙Remote Boot Option 2 uses the HP TopTools Remote Control web interface.
Remote Boot Option 1
To use Remote Boot Option 1 method, you must have properly configured HP TopTools Remote Control. Refer to "Running the HP TopTools Remote Control BIOS Setup Program" in Chapter 4.
In Remote Boot Option 1, you start from the user interface stored in the HP TopTools Remote Control ROM based setup options.
1.Boot the HP NetServer.
2.When the HP TopTools Remote Control banner appears, press F3 when prompted. You are presented with a menu of configurable options.
3.Enable the Remote Boot feature in the BIOS setup. Be sure it is "on."
4.Enter the filename of the boot image.
5.Supply the IP Address of the TFTP server. That is, identify the IP Address of the server where the remote boot image is located.
6.Reboot. During the HP NetServer reboot, a message indicates that the server is attempting to start from the designated boot image.
Remote Boot Option 2
The second remote boot method requires you to log onto the HP TopTools Remote Control web interface in order to set up a remote boot.
To set up a remote boot, using the HP TopTools Remote Control user interface:
1.From the HP TopTools Remote Control user interface, select the Remote Control tab.
2.Under Server Control, select one of the following HP NetServer
79
