HP L65500 Move the printer

3.Lift up the right-hand side of the filter container; it pivots on the left.

4.Pull the old filter out of the bottom of its container and dispose of it according to the instructions provided with the new filter.

5.Unpack the new filters and ensure that the blue tabs at each end of each filter are at right angles to the filter.

6.Insert the new filter into the container.

7.Ensure that the blue tabs on the filters are correctly engaged with the hooks on the containers, otherwise the containers may not close completely.

8.Lower the container into position.

9.Lower the carriage cover and close the door. Press the OK key on the front panel.

10.If you forgot to select Replace cleaner roll before replacing the printhead cleaning roll, you should

now go to the front panel and select Check cleaner roll from the Ink System menu .

Move the printer

If you wish to move the printer a short distance on the same site, across a horizontal floor with no steps and no slopes of more than 5% inclination, see the following instructions. For more difficult movement operations, please call your service representative (see HP Customer Care Centers on page 49).

CAUTION: Slopes steeper than 5% may cause serious damage to the printer.

1.Turn off the printer.

2.Disconnect all power and network cables from the printer.

3.Disconnect all ink cartridges and remove them from the printer. Hold the cartridge connectors in position with adhesive tape.

Hardware maintenance

ENWW	Move the printer 27

Contents

Page Page Table of contents Page Page Page 1 Safety precautions General safety guidelines Electric shock hazard Mechanical hazard Heat hazard Warnings and cautions Warning labels Page Emergency stop buttons 2 Printer status Check printer status Printer alerts 3 Printer calibration Align the printheads Troubleshoot printhead alignment Substrate-advancecompensation Color calibration Page Ink restrictions Color profiles 4 Hardware maintenance Maintain the ink cartridges Maintain the printheads Maintain the substrates Check the printheads Clean the carriage cover Clean the carriage rails Page Clean the exterior of the printer Clean the ink deposits Clean the line sensor and aerosol inlets Clean the main roller Clean the substrate edge holders Clean the pinch wheels Clean the platen Clean the printheads Clean the substrate-advancesensor Clean the temperature sensors Maintain the printhead primers Replace the carriage oiler foams Page Replace the line sensor box Replace the printhead cleaning roll and aerosol filters Page Page Move the printer Printer maintenance kits Cleaning kit 5 Software maintenance Maintain the HP Internal Print Server Update the firmware 6 Troubleshoot substrate issues The substrate cannot be loaded successfully The substrate has jammed The substrate is not attached to the input core The substrate sticks to the platen The ink is still wet when the substrate emerges There are ink marks on the substrate 7 Troubleshoot print-qualityissues General advice Banding Print-qualityissues Colors are misaligned Colors are misaligned vertically Colors are misaligned horizontally The print is grainy The print is smudged The substrate is not flat Edges of objects are rough or blurred Colors look washed out Colors are inaccurate 8Troubleshoot ink cartridge and printhead issues Cannot insert an ink cartridge Cannot insert a printhead The front panel recommends replacing or reseating an ink cartridge The front panel recommends replacing or reseating a printhead A printhead has overheated A printhead has damaged the substrate Incorrect printhead cleaning roll errors 9 Troubleshoot other issues The printer does not print The printer seems slow The HP Internal Print Server cannot detect the printer Upgrade the HP Internal Print Server Print job files have not been properly deleted Color calibration fails 10 Front-panelerror messages Front-panelerrors Page Page 11 When you need help Documentation HP Proactive Support HP Customer Care HP Customer Care Centers Service information A Preset creation flowchart Index