vSelect-In Signal
vData Bit
vBuffer Size
vEmulation
vCharacter Sets
vPrint Language
vAutomatic Carriage Return on Line Feed
vAutomatic Line Feed on Carriage Return
v20 CPI
vNLQ
Interface Type
Youcan set the system interface to match the interface that is attached to your
printer.
vCX Parallel (default)
v1284 Byte
v1284 Nibble
Tochange or check the Interface Types:
1. Ensure the printer is powered off (O).
2. Press and hold Menu/Enter while powering on (|) the printer. The message
STARTING UP displays.
3. After start-up is complete, release Menu/Enter and the message PRINT OUT=NO
displays.
4. Press ↓until the message PARALLEL INTF displays.
5. Press →until the message INTF=xxxxxxxxxxx displays, where xxxxxxxxxxx can
be CX PARALLEL,1284 BYTE,or1284 NIBBLE. If you want to select a value other
than the one displayed, press ←or →.
6. Toexit from Power On Configuration, press Menu/Enter. Your new value is
stored in NVM.
Select-In Signal
Youcan set the select-in signal to:
On The Select-In signal is ignored and treated as always on.
Host (default) Theprinter checks the Select-In signal from the host.
Tochange or check the Select-In Signal:
1. Ensure the printer is powered off (O).
2. Press and hold Menu/Enter while powering on (|) the printer. The message
STARTING UP displays.
3. After start-up is complete, release Menu/Enter and the message PRINT OUT=NO
displays.
4. Press ↓until the message PARALLEL INTF displays.
5. Press →until the message INTF=xxxxxxxxxxx displays, where xxxxxxxxxxx can
be CX PARALLEL,1284 BYTE,or1284 NIBBLE.
6. Press ↓until the message SELECT-IN=xxxx displays, where xxxx can be ON or
HOST. If you want to select a value other than the one displayed, press ←or →.
Chapter4. Configuring Your Printer 85