5. Press →until the message INTF=xxxxxxxxxxx displays, where xxxxxxxxxxx can
be CX PARALLEL,1284 BYTE,or1284 NIBBLE.
6. Press ↓until the message NLQ=xxxxxxx displays, where xxxxxxx can be COURIER
or GOTHIC. If you want to select a value other than the one displayed, press ←or
→.
7. Toexit from Power On Configuration, press Menu/Enter. Your new value is
stored in NVM.
Serial InterfaceSelect this category if your printer is connected to your host computer through an
RS-232C or RS-422A interface. There are several differentparameters available:
vInterface Type
vBaud Rate
vData Bit
vParity
vPacing Protocol
vConnection Type
vBuffer Size
vEmulation
vCharacter Set
vPrint Language
vAutomatic Carriage Return on Line Feed
vAutomatic Line Feed on Carriage Return
v20 CPI
vNLQ
Interface Type
Youcan set the system interface to any of the following values:
vSerial No
vRS-232C (default)
vRS-422A
Tochange or check the Interface Types:
1. Ensure the printer is powered off (O).
2. Press and hold Menu/Enter while powering on (|) the printer. The message
STARTING UP displays.
3. After start-up is complete, release Menu/Enter and the message PRINT OUT=NO
displays.
4. Press ↓until the message SERIAL INTERFACE displays.
5. Press →until the message INTF=xxxxxxxxx displays, where xxxxxxxxx can be
SERIAL NO,RS-232C,orRS-422A. If you want to select a value other than the one
displayed, press ←or →.
6. Toexit from Power On Configuration, press Menu/Enter. Your new value is
stored in NVM.
Chapter4. Configuring Your Printer 91