Rear Tear Mode
This parameter selects the tear-off function for forms that are loaded in the Rear
Push forms path. (See “Checking and Adjusting Tear-OffPosition” on page 25 for
more information about adjusting the tear-off position.) Yourchoices are:
Norm (default) This is the default option. Press Tear to move the form to the tear
line. After a 10 second delay the forms will back down into the
printer. Press Tearagain to move the forms back without waiting for
the 10-second delay.
Auto Once printing finishes, the forms automatically move up to the
tear-off line. The forms remain there until another job is sent to the
printer. When a job is sent, the forms move down to the print
position and printing continues.
No This option disables reverse forms movement. Select No for forms
that should not be moved through the printer in a reverse direction,
such as forms with attached labels and forms with overlays.
Note: Setting this parameter to No modifies how forms park. See
“Parking One Continuous Form and Loading Another (Dual
Push)” on page59 and “Parking Continuous Forms” on
page 29.
Tochange or check the Rear Tear Mode value:
1. Ensure the printer is powered off (O).
2. Press and hold Menu/Enter while powering on (|) the printer. The message
STARTING UP displays.
3. After start-up is complete, release Menu/Enter and the message PRINT OUT=NO
displays.
4. Press ↓until the message FUNCTIONS displays.
5. Press →until the message FRONT TEAR=xxxx displays, where xxxx can be NORM,
AUTO,orNO.
6. Press ↓until the message REAR TEAR=xxxx displays, where xxxx can be NORM,
AUTO,orNO. If you want to select a value other than the one displayed, press ←
or →.
7. Toexit from Power On Configuration, press Menu/Enter. Your new value is
stored in NVM. It takes a few seconds for the new value to be accepted.
Paper Overlay
The paper overlay function allows you to simultaneously feed (and overlay) a single
sheet of paper from the Manual Sheet Feed while processing forms through one of
the push paths (Front Push or Rear Push forms path). Youcan set forms overlay to
one of the following values:
No (default) Disables the printer from feeding simultaneously from the Manual
Sheet Feed and one of the forms paths.
Yes Enables the printer to feed simultaneously from the Manual Sheet
Feed and one of the forms paths.
Notes:
1. The Paper Overlay function cannot be used with the Rear Pull or Push+Pull
forms paths.
100 4247 Printer ModelA00 User’s Guide