Additionally, you can order the following options. Contact your IBM marketing
representative.
vAutomatic Sheet Feeder - Allows feeding of envelopes or from as many as three
additional cut sheet forms paths
vPrinter stand - Especially helpful when using Dual Push forms path
Setting Up Your Printer
The next few steps guide you through removing all packing materials, installing the
operator panel overlay, and installing the wire forms guide.
Removing Packing Materials
1. Remove the printer from the plastic bag.
2. Place the printer on a flat work area, printer stand, or table. Ensure that you
have access to both the front and the rear of the printer. See “AppendixA.
Specifications” on page159 for dimensions of the table and the clearances
required around the printer.
3. Lift the bottom edge of the front tractor cover into the open position.
Chapter1. Printer Setup 3