4. Press ↓until the message VERT ADJUST=xxx displays, where xxx can be -24 to
24. If you want to select a value other than the one displayed, press ←or →.
5. Toexit from Program Configuration, press ↓until the message STORE=QUIT
displays. If you want to exit without saving the new value, press Menu/Enter.
If you want to save the new value, press ←or →to select either STORE=SAVE (new
value is stored in NVM) or STORE=CURRENT (new value remains valid until the
printer is powered off (O)). Press Menu/Enter to save the new value.
Form SettingThis category contains the following parameters for setting a specific forms path:
vLine Spacing
vLine Spacing Lock
vPage Length
vTopof Form
vPerforation Skipping
vFont
vPitch
vPitch Lock
vLeft Margin
vRight Margin
vSlashed Zero
vRestore Mfg Defaults
Line Spacing
Youcan set vertical spacing in lines-per-inch or in lines-per-30 mm on your printer.
Available values are:
v6 LPI (default)
v8 LPI
v12 LPI
v3L/30MM
v4L/30MM
v6L/30MM
v8L/30MM
v12L/30MM
Tochange or check the Line Spacing value:
1. Press Menu/Enter. The message PRINT OUT=NO displays.
2. Press ↓until the message FORM SETTING displays.
3. Press →until the message LINE SP=xxxxxxx displays, where xxxxxxx can be 6
LPI,8 LPI,12 LPI,3L/30MM,4L/30MM,6L/30MM,8L/30MM,or12L/30MM. If you want
to select a value other than the one displayed, press ←or →.
4. Toexit from Program Configuration, press ↓until the message STORE=QUIT
displays. If you want to exit without saving the new value, press Menu/Enter.
If you want to save the new value, press ←or →to select either STORE=SAVE (new
value is stored in NVM) or STORE=CURRENT (new value remains valid until the
printer is powered off (O)). Press Menu/Enter to save the new value.
Chapter4. Configuring Your Printer 113