1. The power switch is located on the lower left side of the printer. Ensure the
printer is powered off (O). DANGER
<1> The construction of this printer provides extra protection against
the risk of electric shock by grounding appropriate metal parts. The
extra protection may not function unless the power cord is connected
to a properly-grounded outlet. This printer has a grounding-type (3-wire)
power cord because grounding is necessary. It is the responsibility of
the customer or the person installing the printer to connect it to a
properly-grounded outlet. Seek professional assistance before using an
adapter or extension cord; such a device could interrupt the grounding
circuit.
If this printer is connected to an outlet that has been incorrectly
connected to the building wiring, serious electric shock could result.
2. The power connector is located at the lower left rear of the printer. Connect the
power cord to the power connector on the printer. Press firmly to ensure that the
plug is securely seated.
3. Plug the power cord into a properly-grounded electric receptacle.
Changing Display Language
The printer default language that appears in the operator panel display of your
printer is English. Youcan change the language by following these steps:
1. If the printer is powered on (|), power off (O) the printer.
2. Enter Power On Configuration mode. Press and continue to hold Menu/Enter
while powering on (|) the printer until (1) the message STARTING UP appears, (2)
the boxes on the operator panel display are solidly filled in, and (3) the
printhead stops. This takes about fifteen seconds. Do not release this key or
press any other keys until this completes.
3. Release Menu/Enter. The message PRINT OUT=NO displays.
4. Press ↓until the message FUNCTIONS displays.
5. Press →and the message FRONT TEAR=NORM displays.
6. Press ↓until the message MENU=xxxxxxxx displays (where xxxxxxxx can be
ENGLISH, ITALIANO, FRANCAIS, ESPANOL,DEUTSCH, PORTUGUES,
DANSK, or NEDERLANDS).
7. Press ←or →until the language you want to use displays.
8. Press Menu/Enter to save the setting and exit Power On Configuration mode.
Regardless of the language you select, STARTING UP always appears in English.
Chapter1. Printer Setup 19