e. Press Menu/Enter to save the settings and exit Power On Configuration
mode. This takes a few seconds. Do not press any keys until this
completes.
f. Press Path until the Front Push indicator is blinking and the message
01 END OF FORMS displays.
g. Press Online to quiet the alarm and put the printer online.
4. Perform the steps in “Loading Forms into Front Push Forms Path” on page20.
Your4247 Printer is ready to print. See “Printing Power On Configuration Setup” on
page 27 and “Printing Program Configuration Setup”on page 28 to print the
configuration. If you do not want to use the printer defaults for forms settings (such
as Line Spacing, Page Length, or Topof Form), see “Program Configuration” on
page 106.
Setting Up Rear Push Forms Path
Figure 31 shows the Rear Push forms path with Manual Sheet Feed.
Ensure the correct settings are made for the Rear Push forms path. Refer to the
tables in “Summarizing Forms Path Set Up” on page39.
Additionally you will need to perform the following tasks:
1. “Installing Rear Push Tractor”
2. “Configuring Forms Path for Rear Push” on page54
3. “Loading Forms For Rear Push” on page55
Installing Rear Push Tractor
Install the forms tractor in the Rear Push forms path as follows:
1. Power off (O) the printer.
2. Open the top cover and the forms guide.
Figure 31. Rear Push Forms Path with Manual Sheet Feed
Chapter3. Setting Up Another Forms Path 53