3. Press →until the message LINE SP=xxxxxxx displays, where xxxxxxx can be 6
LPI,8 LPI,12 LPI,3L/30MM,4L/30MM,6L/30MM,8L/30MM,or12L/30MM.
4. Press ↓until the message RESTORE MFG=xxx displays, where xxx can be NO or
YES. If you want to select a value other than the one displayed, press ←or →.
5. Toexit from Program Configuration, press ↓until the message STORE=QUIT
displays. If you want to exit without saving the new value, press Menu/Enter.
If you want to save the new value, press ←or →to select either STORE=SAVE (new
value is stored in NVM) or STORE=CURRENT (new value remains valid until the
printer is powered off (O)). Press Menu/Enter to save the new value.
Another Path
Youcan set this category to either one of the following values:
No (default) Does not allow you to select another default forms path to
configure.
Yes Lets you return to the Paper Path category in the Program
Configuration menu to configure another default forms path.
Tochange or check the Another Paper Path value:
1. Press Menu/Enter. The message PRINT OUT=NO displays.
2. Press ↓until the message ANOTHER PATH=xxx displays, where xxx can be NO or
YES. If you want to select a value other than the one displayed, press ←or →.
3. Toexit from Program Configuration, press ↓until the message STORE=QUIT
displays. If you want to exit without saving the new value, press Menu/Enter.
If you want to save the new value, press ←or →to select either STORE=SAVE (new
value is stored in NVM) or STORE=CURRENT (new value remains valid until the
printer is powered off (O)). Press Menu/Enter to save the new value.
Additional Entry Point to Power On Configuration Menu
Note: Youcannot access the Pull category or the Forms Jam category from this
entry point. Youmust use the method outlined in “Power On Configuration”
on page 82.
Youcan enter the Power On Configuration menu without powering off and powering
on the printer by using the Program Configuration menu. Available values for this
category are:
No (default) Does not allow you to return to the Power On Configuration menu.
Yes Allows you to return to the Power On Configuration menu. If you
press ↑or ↓, you will return to the start of the menu, PRINT OUT=NO.
Entering the Power On Configuration menu through the Program
Configuration menu does not allow you to access the PULL or JAM
SENSORS categories.
Toenter the Power On Configuration menu from the Program Configuration menu:
1. Press Menu/Enter. The message PRINT OUT=NO displays.
2. Press ↓until the message CONFIG MENU=xxx displays, where xxx can be NO or
YES. If you want to select a value other than the one displayed, press ←or →.
3. Toexit from Program Configuration, press ↓until the message STORE=QUIT
displays. If you want to exit without saving the new value, press Menu/Enter.
Chapter4. Configuring Your Printer 119