Ensure the correct settings are made for the Dual Push forms path. Refer to the
tables in “Summarizing Forms Path Set Up” on page39.
Preparing Dual Push Forms Paths
Because this forms path configuration lets you alternate (either manually or
automatically) between the Front Push and Rear Push forms paths, you will load
forms into both forms paths.
1. Stack the forms as shown in Figure 37. The top of the input forms stack should
be lower than the bottom of the printer.
2. If the Front Push forms path is not setup, go to “Setting Up and Configuring
Front Push Forms Path” on page52 and set up the Front Push forms path, and
then return here to step 3.
3. Park the forms in the Front Push forms path (see “Parking Continuous Forms”
on page 29), and then return here to step 4.
4. If the Rear Push forms path is not setup, go to “Setting Up Rear Push Forms
Path” on page53 and set up the Rear Push forms path. Return here to step 5.
5. Park the forms in the Rear Push forms path (see “Parking Continuous Forms”
on page 29). Return here to “Configuring Printer for Linking Dual Push”on
page 59.
Figure 36. Dual Push Forms Paths with Manual Sheet Feed
Figure 37. Stacking Forms for Dual Push. See page 32 if your printer uses the optional
printer stand.
58 4247 Printer ModelA00 User’s Guide