The following values are used for NN:
0Disable ASF.Ejects any form loaded from bin 1, 2, or 3, and selects Manual
Sheet Feed forms path.
1Selects bin 1 if no forms are loaded; otherwise, the next form is loaded
from bin 1 when data is received.
2Selects bin 2 if no forms are loaded; otherwise, the next form is loaded
from bin 2 when data is received.
3Selects bin 3 if no forms are loaded; otherwise, the next form is loaded
from bin 3 when data is received.
4Selects the last bin in use after the Deselect ASF command.A form will be
loaded when data is received.
CSelects bin 1 for the first form; then selects bin 2 for all subsequent forms.
REjects the currently loaded cut-sheet form.
Set Intercharacter Spacing (ESC SP)1B 20 NN
This control sets the amount of space to be added to the right of each character.
The number of units of space is equal to NN, from 0 to 127. Each unit of space is
1/120th of an inch.
Master Select (ESC !)1B 21 NN
This control selects any valid combination of the modes in the table below. To
determine the value of the NN, add together the values of the modes you select
from the table.
Mode Decimal Hex
10 CPI 0 00
12 CPI 1 01
Proportional 2 02
Condensed 4 04
Emphasized 8 08
Double-Strike 16 10
Double-Wide 32 20
Italic 64 40
Underline 128 80
This control applies to DP and NLQ. Proportional cannot be condensed and 10 CPI
cannot be combined with 12 CPI. Proportional overrides condensed if both
proportional and condensed are selected. Double-strike is ignored in NLQ.
Cancel MSB Control (ESC #)1B 23
228 4247 Printer ModelA00 User’s Guide