Table11 directs you to information about the forms path of your choice.
Table11. Information About Your Selected Forms Path
Forms Path Where to Find YourNext Task
Front Push “Setting Up and Configuring Front Push Forms Path”
Rear Push “Setting Up Rear Push Forms Path” on page 53
Dual Push “Setting Up Dual Push Forms Paths” on page 57
Rear Pull “Setting Up Rear Pull Forms Path”on page 60
Push Pull “SettingUp Push Pull Forms Path” on page 70
Setting Up and Configuring Front Push Forms Path
Figure 30 shows the Front Push forms path with Manual Sheet Feed.
The Front Push tractor is used for the Dual Push and the Push Pull forms paths, as
well as the Front Push forms path. The printer is shipped to you with the Front
Push forms path set as the default.
1. Ensure the correct settings are made for the Front Push forms path. Refer to
the tables in “Summarizing Forms Path Set Up” on page39.
2. Perform the steps in “Installing Front Push Tractor”on page 15.
3. Configure the printer for the Front Push forms path by following these steps:
a. Power off (O) the printer.
b. Enter Power On Configuration mode. Todo this, press and continue to hold
Menu/Enter while powering on (|) the printer, until (1) the message STARTING
UP appears, (2) the boxes on the operator panel display are solidly filled in,
and (3) the printhead stops. This takes about fifteen seconds. Do not
release this key or press any other keys until this completes.
c. Release Menu/Enter and the message PRINT OUT=NO displays.
d. Press ↓and the message PULL=xxxxxxxxx displays, where xxxxxxxxx can be
NO,YES,orPUSH+PULL. If xxxxxxxxx is not NO, press ←or →until NO is
displayed.
Figure 30. Front Push and Manual Sheet Feed Forms Paths
52 4247 Printer ModelA00 User’s Guide