1. Press Menu/Enter. The message PRINT OUT=NO displays.
2. Press ↓until the message FORM SETTING displays.
3. Press →until the message LINE SP=xxxxxxx displays, where xxxxxxx can be 6
LPI,8 LPI,12 LPI,3L/30MM,4L/30MM,6L/30MM,8L/30MM,or12L/30MM.
4. Press ↓until the message TOP OF FORM=xxx displays, where xxx can be 0to 660.
If you want to select a value other than the one displayed, press ←or →.
5. Toexit from Program Configuration, press ↓until the message STORE=QUIT
displays. If you want to exit without saving the new value, press Menu/Enter.
If you want to save the new value, press ←or →to select either STORE=SAVE (new
value is stored in NVM) or STORE=CURRENT (new value remains valid until the
printer is powered off (O)). Press Menu/Enter to save the new value.
Perforation Skipping
Youcan set the number of units you want skipped over the perforation from 0 to
660 units (where each unit is 4.23 mm [1/6 in.]). The default value is 0.
Tochange or check the Perforation Skipping value:
1. Press Menu/Enter. The message PRINT OUT=NO displays.
2. Press ↓until the message FORM SETTING displays.
3. Press →until the message LINE SP=xxxxxxx displays, where xxxxxxx can be 6
LPI,8 LPI,12 LPI,3L/30MM,4L/30MM,6L/30MM,8L/30MM,or12L/30MM.
4. Press ↓until the message SKIP PERF=xxx displays, where xxx can be 0to 660.If
you want to select a value other than the one displayed, press ←or →.
5. Toexit from Program Configuration, press ↓until the message STORE=QUIT
displays. If you want to exit without saving the new value, press Menu/Enter.
If you want to save the new value, press ←or →to select either STORE=SAVE (new
value is stored in NVM) or STORE=CURRENT (new value remains valid until the
printer is powered off (O)). Press Menu/Enter to save the new value.
Font
Youcan set the font on your printer to any of the following values:
vDP (default)
vDP Text
vCourier
vGothic
vOCR-A
vOCR-B
Tochange or check the Font value:
1. Press Menu/Enter. The message PRINT OUT=NO displays.
2. Press ↓until the message FORM SETTING displays.
3. Press →until the message LINE SP=xxxxxxx displays, where xxxxxxx can be 6
LPI,8 LPI,12 LPI,3L/30MM,4L/30MM,6L/30MM,8L/30MM,or12L/30MM.
4. Press ↓until the message FONT=xxxxxxx displays, where xxxxxxx can be DP,DP
TEXT,COURIER,GOTHIC,OCR-A,orOCR-B. If you want to select a value other than
the one displayed, press ←or →.
5. Toexit from Program Configuration, press ↓until the message STORE=QUIT
displays. If you want to exit without saving the new value, press Menu/Enter.
Chapter4. Configuring Your Printer 115